Description
Command Access PM300 Power Booster Interface Module for an Electric Latch Pullback Exit Device
The patented PM300 (taking over from all PM200 & PWM200 units) power booster module is an interface module that connects between the solenoid circuit of a latch-pullback exit device and the power supply. The PM series modules have been offering a reliable, cost-effective interface solution for exit devices for nearly a decade. The PM300 series modules integrate all the upgrades and improvements we’ve made over the years and are available for nearly all exit device applications.
Over the past decade our customers have discover different uses for this module which include the following:
- Allows a solenoid-driven exit device to be used with a lower cost power supply – The PM300 provides a local power boost and will work with most 1.5 A or greater, 24VDC, non-switching power supplies, eliminating the need for the expensive “specialty” power supply.
- Longer wire runs from the power supply to the exit device– Since the PM300 is the located in the exit device the allowable distance between the power supply and the exit device without compromising the performance of the device increases significantly.
- Gives a needed boost to an anemic power supply/exit device installation – For various reason our customers have encountered conditions where the PM300 saves the day! The anemic conditions could be due to marginal power supply, minor device binding, too small of gauge wire run, too long of a wire run to name a few.
Installation Instructions
